• Designed to be mixed with fine edger dust • Will match color of the wood floor being filled • Accepts stain • Very fast drying   MSDS

LWF-500-5G
LWF-100-G

Technical Data:
USES: Precision Liquid Wood Filler, a lacquer based product, is designed for use by professionals who specialize in the refinishing of hardwood floors. It is made to be mixed with fine edger dust to match the color of the floor being filled. Precision Liquid Wood Filler will accept stain as does the wood. This product is very fast drying and is to be used on wood floors only.

SURFACE PREPARATION: Thoroughly vacuum the floor before application. Be sure all cracks are free of dust.

MIXING: Always use the fine edger dust (100 grit or finer). After initial sanding, mix Precision Liquid Wood Filler and the fine dust. Keep adding Precision Liquid Wood Filler until the mixture becomes trowelable (stir until blended). "Finer edger dust gives more accurate color. Adjust mixture for trowel or spot filling."

PRIOR TO APPLICATION: Open all windows and doors. Prevent build-up of vapors. Keep away from heat, sparks, and open flame. DO NOT smoke. Extinguish all flames and pilot lights and turn off stove, heaters, electric motors, and other sources of ignition during use and until all vapors are gone. To avoid breathing vapors or spray mist, open windows and doors or use other means to ensure fresh air entry during application and drying. Wear NIOSH/MSHA respirator. Vapors may spread long distances. Vapors ignite explosively.

APPLICATION: Apply between machine sandings. Pour a workable puddle of filler on the floor. Apply Precision Liquid Wood Filler and sawdust mixture across the floor using a smooth trowel or broad knife. Use a putty knife if spot filling butt end joints only. Apply sufficient pressure to force material into the cracks. Leave no excess filler on the surface of the wood. Used mixture will redissolve when returned to container. Large cracks and holes may need an additional application.

DRYING TIME: Allow 20 to 30 minutes with ventilation.

CLEAN UP: Use lacquer thinner for clean up.

IMPORTANT TIPS:
Keep container closed when not in use.
Extinguish all pilot lights and electrical equipment during use.
Use with adequate ventilation.
Wear a NIOSH/MSHA approved respirator during application and sanding of excess filler
Filler left in the grain around cracks and joints will show through the stain and finish.

PACKAGING:
Gallon 4/Case
5 Gallon 1/Case

TECHNICAL DATA
INGREDIENTS: Contains: Acetone, toluene, keytones, alcohols, aliphatic naptha.
SOLUBILITY IN WATER: No VOC: 5.51 lb/gl (660 g/L) BOILING RANGE: 133ºF to 232ºF @ 760mmHG
VAPOR DENSITY: Heavier than Air FLASH POINT: 1ºF